Valve Pin Modification By Mathew "SuPrBuGmAn" Bull
This will allow more airflow to the striker to help recock the marker while running at lower operating pressures.
Remove your valve pin, cupseal, valve spring, valve spring guide, and LPC.
I then sanded down the sides of the valve pin (2 sides). This will allow more airflow to the striker.
This is the valve pin after I sanded it down (side view). Notice how much smaller in diameter it is from the side than it used to be. This is the finished product.
Mat "SuPrBuGmAn" Bull © 2001
Visit The Spyder-Club
~§þ¥Ðë®~1st Gëñë®Å†ïõñ §†ÅñÐŮР{£þ}
~ÅKÅ §þ¥Ðë® V£M{In the works)
~ÅÇï MÅvë®ïÇK УX
~®Hïñõ §þï†Fï®ë
This article reproduced at the SpyderZone under consent of the author, Mat "SuPrBuGmAn" Bull. Duplication of any material in this article is prohibited except by permission of the author.
